FFA 2004
  • Ffa2004 angle removebg preview
  • Ffa2004 removebg preview
  • Ffa2004 back removebg preview

FFA 2004

FFA

A new addition to the four channel power amplifier range

The FFA-2004 has 4 channels with output up to 1000 W connected to a 2 Ohm load. It has the same thermal capacity and power supply components as used in the higher power models in the range the FFA-4004 and FFA-6004. This gives the FFA-2004 very high thermal capacity and increased reliability so is ideal for installation in very demanding installations. Audio performance is excellent and the punchy sound gives the impression of more power than specified.

Key Features

  • 4 x 250 Watts ref 8 Ohms / 4 x 500 Watts ref 4 Ohms
  • Exceptional sound quality
  • G2 DSP option
  • Mains power efficient and cool running
  • Rugged Tour class Aluminium construction
  • Light weight - 9 kg
  • FFA Class D PWM
  • High current switch mode power supply
  • Superb limiter
  • 4 XLR analogue audio inputs
  • 4 XLR parallel outputs
  • Bi amp Neutrik® speakON outputs
  • Signal Link through
  • Neutrik® powerCON power input
  • PSU soft start
  • Hand built & designed in Hertfordshire, England
  • 5 year factory warranty

Technical Specification

Power Ratings
4 x 250W 8 Ohm load 4 x 500W 4 Ohms load
Gain
32 dB
THD
THD Typical 0.03 4 Ohm 1kHz THD+N
Frequency Response
20Hz - 20kHz +- 0.5dB
Controls
40 Point Potentiometer per channel, power on switch
Indicators
signal green = -20dB, signal yellow = -3dB, red signal = clip, signal red protect = over current, low AC mains or 3 sec. mute on power up Load Protection DC on output, clip limiter
Load Protection
DC on output, clip limiter circuit
Amplifier Protection
Amplifier Protection Short circuit, current overload, thermal shutdown, high frequency stability circuit
Audio Signal Inputs
Balanced Neutrik® Female XLR input connected Pin 1 - GND, Pin 2 - Hot +, Pin 3 - Cold - . XLR Male signal parallel each channel
Audio Signal Outputs
Neutrik® speakON each channel. Channels 1 and 3 output speakON utilises 2+ and 2- connection to allow use of 4 core loudspeaker cable for bi amp loudspeaker system for example stage monitor system
Power Requirement
1 x Neutrik® 20A powerCON connector 1 x 16 A 230 VAC Circuit. Power range 185 V-230 VAC 120 V (configured at factory)
System Cooling
High CFM 80mm fan with proportional signal speed control. Rear to front airflow
Dimensions
88mm Height x 483mm Width x 510mm Depth. Includes rear rack support. 19" rack mount enclosure
Weight
9 kg

Classic Series

Browse the complete Classic Series range here